The Innosilicon A10 is one example of an Ethereum ASIC that boasts high performance. Two Miner has recently begun delivering A10 machines to the operation there. The NiceHash protocol is supported by our pools along with the ASIC-compatible Stratum protocol. Using ASICs like the Innosilicon A10 Pro and renting hashing power from NiceHash will help you mine cryptocurrency more efficiently.
An Assessment Of The Performance Of The Innosilicon A10 And Gpu-Based Mining Systems
The potential profit can be calculated using 2CryptoCalc. Just enter the parameters and the calculator does the rest. If you pay $2,500 to Innosilicon A10, you will get $8.93 per day. Currently, this device will pay for itself (excluding electricity costs) in about nine to ten months.
Using 1 Mh/s of hashing power, we can calculate its price. If you want to mine Ethereum, you will have to pay $5 for the Innosilicon A10. This is a huge step forward for mining hardware development. Previously, ASIC devices or GPU mining rigs could be obtained for $9-10 per megahash. Thus, A10 mining equipment is twice as efficient as conventional mining equipment. Additionally, you must keep in mind that mining requires quite a bit of effort and time. A bitcoin mining rig capable of 1Mh/s would cost similar to the Innosilicon A10 when using used equipment.
Compared to the mining rig innosilicon A10, the NVIDIA 1070 uses approximately 1000 W with eight GPUs. The A10 has a hashrate of 500 Mh/s, but this mining rig gives you 250 Mh/s.
Due to the ASIC’s efficiency, not only is it more economical, but also it is more energy efficient by more than twofold than a GPU miner. One of the main disadvantages of ASIC devices is that they cannot be resold after they have been used. Furthermore, ASICs are extremely difficult to repair as compared to mining rigs. Our article ASIC vs. GPU Mining Rig: Which is Better examined the differences between the two.
Instructions For Installing The A10 From Innosilicon
Ethereum and Ethereum Classic can be mined with the Innosilicon A10 chip on 2Miners. It is not recommended to use SOLO mode if you have only one A10 device. You will receive stable and consistent rewards by joining the PPLNS pool. In the SOLO mode of 2CryptoCalc, you can determine the estimated daily reward for a particular cryptocurrency as well as how long it takes to find a new block of cryptocurrency. Our recommendation is that you use SOLO mining if you can find at least 1-2 blocks per day on average. Innosilicon A10 machines are therefore necessary to run ETC, while nearly 100 machines are needed to run ETH.
Here are the settings you should use when mining Ethereum with Asics:
During the process of speeding up the ASIC, please wait. As a result, it could take up to 30 minutes to reach the 500 m/s declared. It is important to remember that your miner’s hash rate depends on how much it sends to the pool. Having zero hashrate for the first few minutes is absolutely normal.